Report (24) Oregon Residential Specialty Code N1107.2
HIGH-EFFICIENCY INTERIOR LIGHTING SYSTEMS
Permit No.: Jurisdiction:
�, i `i- vcci L
--'5
Site Address:
Subdivision/Lot#:
and/or
Map and Tax Lot#: 3
By my signature below, I certify that all of the permanently installed lighting fixtures in the
above mentioned building contain high-efficacy lamps. Screw-in compact fluorescent and LED
lamps comply with this requirement. (Oregon Residential Specialty Code N1107.2)1
Signature: �,,�� Date: (17
Owner/ eneral'Contractor/Authorized Agent
4 Print Name:
' ORSC Section N1107.2.High-efficacy lamps. All permanently installed lighting fixtures shall contain high-
efficacy lamps. Screw-in compact fluorescent and LED lamps comply with this requirement.
The building official shall be notified in writing at the final inspection that the permanently installed lighting fixtures
have met this requirement.
Exception: Two permanently installed lighting fixtures are not required to have high-efficacy lamps.
1:\Building\Forms\RES-H ighEfficiencyLightingAcknowledgement_022018
Oregon Residential Specialty Code R318.2
MOISTURE CONTENT ACKNOWLEDGEMENT FORM
I, L... . , am the general contractor or the owner-builder
at the fo owing address:
Site Address: 7 2
City: NC-r‘'`
Permit#: cr-IAD
Subdivision/Lot#:
and/or
Map and Tax Lot#:
To conform with the 2017 Oregon Residential Specialty Code (ORSC), Section R318.2 and
OAR 918-480-0140, I am notifying the building official that I am aware of the moisture content
Requirement of ORSC Section R318.2 and have taken steps to meet this code requirement.
[Section R318.2 is provided for reference].
R318.2 Moisture Content: Prior to the installation of interior finishes, the building
official shall be notified in writing by the general contractor that all moisture-sensitive
wood framing members used in construction have a moisture content of not more than 19
percent by dry weight of dry framing members.
Signature: 11-'A.2 Date: 7 A--f?
General Contractor or Owner-Builder
I:\Building\Form\RES-MoistureContentAcknowledgement_022018
Oregon Residential Specialty Code R408.1
ISTURE BARRIER ACKNOWLEDGEMENT FORM
, am the general contractor or the owner-builder
at the fol owing address:
Site Address:
Z r S> ccc\c,NA-
City:
Permit#:
\`1— 1
Subdivision/Lot#:
and/or
Map and Tax Lot#:
37
To conform with the 2017 Oregon Residential Specialty Code (ORSC), Section R408.1
Ventilation. I am notifying the building official that I have installed the Moisture Barrier as per
Requirement in ORSC Section 408.1 and have taken the following steps to meet this code
requirement:
IrA The ground surface of the under-floor space is covered by a Class I vapor retarder or
other approved materials, with
Joints lapped 12 inches at seams and
Extending up the foundation walls 12 inches.
Signature: Date: /tr
General"Contractor or Owner-Builder
I:\Building\Form\RES-MoistureBarrierAcknowledgement_022018
✓y) si 9,0id7 - 0oC i 6
c .,,rr
„ rum Aim- • .4+ t
:___' , ,J. '''',' bt, III S I
,.,,,,,,„,„,,,.,„7: Local Relationships.National Resources.
USI JB Insulation
14255 SW Galbreath Drive
Sherwood. OR 97140
Installed Insulation Certificate
We certify that the insulation material listed here was installed at the address listed below:
Other tion
Loose hili&: loose iYlt only r; t otunYinum foal only
aluminum foil I
Aluminum No.of .Covera a Initial Installed 8,
Foam 9 Minimum Settled Air Spa Direction of
Loose Fill Kraft Unfaced Foil Open/Closed BIBS® R-Value Thickness Pkgs :Area(SF) "Thickness too Tffudv s Heat Fkwv
Attic (] ❑ ❑ ❑ ❑ ❑ R-49
Ceilings ❑ ❑ ❑ ❑ ❑ ❑ j
Floors ❑ ❑ e ❑ ❑ ❑ R-38
Walls El El ❑ ❑ ❑ ❑ R-21
Basement [J 0 ❑ ❑ ❑ ❑
Crawlspace ❑ ❑ 0 ❑ ❑ ❑ R-38
Garage Exterior ❑ 0 ❑ ❑ ❑ ❑ R-19 l '
Walls _._�.... ._. ,
. — �O�w� &.e.\<• Address or Lot Number: 7727 SW Cornutt St,lot 39
Contractor
(Signature) City,ST Zip: Portland,OR 97224
Operations Support Specialist Date Installed:
Title
1T.OPS.FRM.010