Report (54) r
L-Series Specifications
Architect/Engineer Specifications
General
L-Series standard horns,strobes,and horn strobes shall mount to a standard 2 x 4 x 1 7/8-inch back box,4 x 4 x 11/2-inch back box,4-inch
octagon back box,or double-gang back box.L-Series compact products shall mount to a single-gang 2 x 4 x 17/6-inch back box.A universal
mounting plate shall be used for mounting ceiling and wall products for all standard models and a separate universal mounting plate shall be
used for mounting wall compact models.The notification appliance circuit wiring shall terminate at the universal mounting plate.Also,L-Series
products,when used with the Sync•Circuit'"Module accessory,shall be powered from a non-coded notification appliance circuit output
and shall operate on a nominal 12 or 24 volts.When used with the Sync•Circuit Module,12-volt-rated notification appliance circuit outputs
shall operate between 8.5 and 17.5 volts;24-volt-rated notification appliance circuit outputs shall operate between 16.5 and 33 volts.Indoor
L-Series products shall operate between 32 and 120 degrees Fahrenheit from a regulated DC or full-wave rectified unfiltered power supply.
Strobes and horn strobes shall have field-selectable candela settings including 15,30,75,95,110,135,and 185.
Strobe
The strobe shall be a System Sensor L-Series Model listed to UL 1971 and shall be approved for fire protective service.The strobe
shall be wired as a primary-signaling notification appliance and comply with the Americans with Disabilities Act requirements for visible
signaling appliances,flashing at 1 Hz over the strobe's entire operating voltage range.The strobe light shall consist of a xenon flash tube and
associated lens/reflector system.
Horn Strobe Combination
The horn strobe shall be a System Sensor L-Series Model listed to UL 1971 and UL 464 and shall be approved for fire protective
service.The horn strobe shall be wired as a primary-signaling notification appliance and comply with the Americans with Disabilities Act
requirements for visible signaling appliances,flashing at 1 Hz over the strobe's entire operating voltage range.The strobe light shall consist
of a xenon flash tube and associated lens/reflector system.The horn shall have two audibility options and an option to switch between a
temporal three pattern and a non-temporal(continuous)pattern.These options are set by a multiple position switch.The horn on horn strobe
models shall operate on a coded or non-coded power supply.
Synchronization Module
The module shall be a System Sensor Sync•Circuit model MDL3 listed to UL 464 and shall be approved for fire protective service.The module
shall synchronize SpectrAlert strobes at 1 Hz and horns at temporal three.Also,while operating the strobes,the module shall silence the horns
on horn strobe models over a single pair of wires.The module shall mount to a 411/16 x 411/16 x 21/8-inch back box.The module shall also
control two Style Y(class B)circuits or one Style Z(class A)circuit.The module shall synchronize multiple zones.Daisy chaining two or more
synchronization modules together will synchronize all the zones they control.The module shall not operate on a coded power supply.
Physical/Electrical Specifications
Standard Operating Temperature 32°F to 120°F(0°C to 49°C)
Humidity Range 10 to 93%non-condensing
Strobe Flash Rate 1 flash per second
Nominal Voltage Regulated 12 DC or regulated 24 DC/FWR1.2
Operating Voltage Range 8 to 17.5 V(12 V nominal)or 16 to 33 V(24 V nominal)
Operating Voltage Range MDL3 Sync Module 8.5 to 17.5 V(12 V nominal)or 16.5 to 33 V(24 V nominal)
InputTerminal Wire Gauge 12 to 18 AWG
Wall-Mount Dimensions(including lens) 5.6"L x 4.7"W x 1.91"D(143 mm L x 119 mm W x 49 mm D)
Compact Wall-Mount Dimensions(including lens) 5.26"L x 3.46"W x 1.91"D(133 mm L x 88 mm W x 49 mm D)
Horn Dimensions 5.6"L x 4.7"W x 1.25"D(143 mm L x 119 mm W x 32 mmD)
Compact Horn Dimensions 5.25"L x 3.45"W x 1.25"D(133mm L x 88mm W x 32mm D)
1.Full Wave Rectified(FWR)voltage is a non-regulated,time-varying power source that is used on some power supply and panel outputs.
2.Strobe products will operate at 12 V nominal only for 15 cd and 30 cd.
r
UL Current Draw Data
UL Max.Strobe Current Draw(mA RMS) UL Max.Horn Current Draw(mA RMS)
8-125 Volts 16-33 Volts 8-17.5 Volts 16-33 Volts
Candela DC DC FWR Sound Pattern dB DC DC FWR
Candela 15 88 43 60 Temporal High 39 44 54
Range 30 143 63 83 Temporal Low 28 32 54
75 N/A 107 136 Non Temporal High 43 47 54
95 N/A 121 155 Non-Temporal Low 29 32 54
110 N/A 148 179 3.1 KHz Temporal High 39 41 54
135 N/A 172 209 3.1 KHz Temporal Low 29 32 54
185 N/A 222 257 3.1 KHz Non-Temporal High 42 43 54
3.1 KHz Non-Temporal Low 28 29 54
Coded High 43 47 54
3.1 KHz Coded High 42 43 54
UL Max.Current Draw(mA RMS).2-Wire Horn Strobe.Candela Range(15-115 cd)
8-17.5 Volts 16-33 Volts
DC Input 15cd 30cd 15cd 30cd 75cd 95cd 110cd 135cd 185cd
Temporal High 98 158 54 74 121 142 162 196 245
Temporal Low 93 154 44 65 111 133 157 184 235
Non-Temporal High 106 166 73 94 139 160 182 211 262
Non-Temportal Low 93 156 51 71 119 139 162 190 239
3.1K Temporal High 93 156 53 73 119 140 164 190 242
3.1K Temporal Low 91 154 45 66 112 133 160 185 235
3.1K Non Temporal High 99 162 69 90 135 157 175 208 261
3.1K Non Temporal Low 93 156 52 72 119 138 162 192 242
16-33 Volts
FWR Input 15cd 30cd 75cd 95cd 110cd 135cd 185cd
Temporal High 83 107 156 177 198 234 287
Temporal Low 68 91 145 165 185 223 271
Non-Temporal High 111 135 185 207 230 264 316
Non-Temportal Low 79 104 157 175 197 235 283
3.1K Temporal High 81 105 155 177 196 234 284
3.1K Temporal Low 68 90 145 166 186 222 276
3.1K Non-Temporal High 104 131 177 204 230 264 326
3.1K Non-Temporal Low 77 102 156 177 199 234 291
Horn Tones and Sound Output Data
Horn and Horn Strobe Output(dBA)
8-17.5 16-33
Switch Volts Volts
Position Sound Pattern dB DC DC FWR
1 Temporal High 84 89 89
2 Temporal Low 75 83 83
3 Non-Temporal High 85 90 90
4 Non-Temporal Low 76 84 84
5 3.1 KHz Temporal High 83 88 88
6 3.1 KHz Temporal Low 76 82 82
7 3.1 KHz Non-Temporal High 84 89 89
8 3.1 KHz Non-Temporal Low 77 83 83
9* Coded High 85 90 90
10* 3.1 KHz Coded High 84 89 89
Settings 9 and 10 are not available on the 2-wire horn strobes.
• �
L-Series Dimensions
1.91 +—_3.46 —0. rol-- 125
+2—3.46 —s 1.25
,44.0.04•• 1111527 5.27
•o's°sYs
AsAassee
cru„ `•i s•e
1___—_ ommiP
ill
Compact Strobe/Horn Strobe Compact Horn
= 4.70 =
1.91
4.70 1.25
1.25
5.67 •il .67 . '
/AM* III. Al ,.1..' -
Strobe I Horn Strobe Horn
L-Series Ordering Information
Model Description Model Description
Wall Horn Strobes Horns
P2RL 2-Wire,Horn Strobe,Red HRL Horn,Red
P2WL 2-Wire,Horn Strobe,White HWL Horn,White
P2GRL 2-Wire,Compact Horn Strobe,Red HGRL Compact Horn,Red
P2GWL 2-Wire,Compact Horn Strobe,White HGWL Compact Horn,White
P2RL-P 2-Wire,Horn Strobe,Red,Plain Accessories
P2WL-P 2-Wire,Horn Strobe,White,Plain TR-2 Universal Wall Trim Ring Red
P2RL-SP 2-Wire,Horn Strobe,Red,FUEGO TR-2W Universal Wall Trim Ring White
P2WL-SP 2-Wire,Horn Strobe,White,FUEGO SBBRL Wall Surface Mount Back Box,Red
Wall Strobes SBBWL Wall Surface Mount Back Box,White
SRL Strobe,Red SBBGRL Compact Wall Surface Mount Back Box,Red
SBBGWL Compact Wall Surface Mount Back Box,White
SGRL Compact Strobe,Red
SGWL Compact Strobe,White
SRL-P Strobe,Red,Plain
SWL-P Strobe,White,Plain
SRL-SP Strobe,Red,FUEGO
SWL-CLR-ALERT Strobe,White,ALERT
Notes:
All-P models have a plain housing(no"FIRE"marking on cover)
All-SP models have'FUEGO"marking on cover
All-ALERT models have"ALERT"marking on cover
SYSTEM
3825 Ohio Avenue•St.Charles,IL 60174 02017 System Sensor
�� S
/�p Phone:800-SENSOR2•Fax:630-377-6495 " "' subject to '" MOM.VettSy81""se190'G01A
I.#I i www.systemsensor.com tor nt° information.
AWS8885503 03/17 a tl•t•sheet.