Plans ct e or60-a 5
/off ,ski r ei2. , /Z/
tqco Fire & Building EW ED
Products DEC 0 7 2006
CITY OF - flCiARD
Technical Services: Tel: (800) 381 -9312 / Fax: (800) 791 -5500 BLITARjG DsVODM
Series RFII — 5.6 K- factor
"Royal Flush 11" Pendent Concealed Sprinklers
Quick & Standard Response, Standard Coverage
General Cap. The Protective Cap is temporarily
removed for installation, and then it
can be replaced to help protect the
Description sprinkler while the ceiling is being in- ': , ` ti,
°
stalled or finished. The tip of the Pro- a %-..E� -�:
The Series RFII Quick Response tective Cap can also be used to mark .'�
(3 mm bulb) & Standard Response (5 the center of the ceiling hole into plan- 4., '
= " ,
mm bulb), 5.6 K- Factor, "Royal Flush Y ter board, ceiling tiles, etc. by gently ,„ F ''
II" Concealed Pendent Sprinklers are pushing the ceiling product against the
decorative sprinklers featuring a flat Protective Cap. When the ceiling in- „ <,. `„ "``':"4,1
cover plate designed to conceal the ' :71 Ah : <.
P 9 stallation is complete the Protective ;?,e;, >, ; , : -' ; 7 -, • ,
sprinkler. It is the best choice for archi Cap is removed and the Cover Plate s =:•:
sensi areas such as hotel ' �'`° F
Y Assembly installed. =`:w� gi p . �
tecturally VA;,;.•,,;
lobbies, office buildings, churches, w °H
and restaurants. As an option, the Series RFII Standard
Response (5 mm bulb) "Royal Flush II” .
Each unit includes a Cover Plate As- Concealed Pendent Sprinklers may be
sembly that conceals the sprinkler op- fitted with a silicone Air and Dust Seal UL, C -UL, and NYC. Maximum 175
erating components above the ceiling. (Ref. Fig. 5). The Air and Dust Seal is psi (12,1 bar) by FM.
The separable two -piece design of the intended for sensitive areas where it is
Cover Plate and Support Cup Assem- desirable to stop air and dust travel Technical
blies allows installation of the sprin- through the cover plate from the area
klers and pressure testing of the fire above the ceiling. Data
protection system prior to installation WARNINGS
of a suspended ceiling or application The Series RFII Concealed Pendent Approvals for Series RFII
of the finish coating to a fixed ceiling. pP
They also permit removal of sus Sprinklers described herein must be UL and C -UL Listed. FM Approved.
pended ceiling panels for access to installed and maintained in compli- NYC under MEA 353 -01 -E. LPCB (Ref.
building service equipment without ance with this document, as well as No. 094a/09 for TY3551 & 094a110 for
having to first shut down the fire pro- with the applicable standards of the TY3531) Approved.
tection system and remove sprinklers. National Fire Protection Association, The approvals apply only to the serv-
Also, the se arable two lace desi n in addition to the standards of any ice conditions indicated in the Design
of the the Sprink provides for g2 other authorities having jurisdiction. Criteria section and maximum pres-
inch (12,7 mm) of vertical adjustment, Failure to do so may impair the per sure ratings indicated in the
formance of these devices. Model/Sprinkler Identification Num-
to reduce the accuracy to which the The owner is responsible for maintain- bers section.
length of fixed pipe drops to the sprin- P
klers must be cut. ing their fire protection system and de- Approvals for Air & Dust Seal
vices in proper operating condition. Part #10908100
The Series RFII Sprinklers are The installing contractor or sprinkler U L and C -UL Li for use with the
shipped with a Disposable Protective manufacturer should be contacted RFII (TY3551 & TY3504) Standard Re-
with any questions. sponse Concealed Sprinkler.
Always refer e thnical Data Model /Sprinkler 155F/68C Ratings
155F/68C Sprinkler - 135F/57C Plate
Sheet TFP700 for the "INSTALLER 200F/93C Sprinkler - 165F/74C Plate
WARNING" that provides cautions Identification Discharge Coefficient
with respect to handling and instal- K = 5.6 GPM /psi (80,6 LPM /bar
lation of sprinkler systems and corn- Numbers Adjustment
ponents. Improper handling and in- 1/2 inch (12,7 mm)
- stallation can permanently damage TY3551 (5mm bulb) & TY3531 (3 mm Finishes
a sprinkler system or its compo- bulb): maximum 175 psi (12,1 bar) by Cover Plate: Chrome Plated, Brass
nents and cause the sprinkler to fail UL, C -UL, FM, LPCB and NYC.
to operate in a fire situation or cause TY3504 (5 mm bulb) & TY3505 (3 mm Plated, or White Painted (Custom paint
it to operate prematurely. bulb): maximum 250 psi (17,3 bar) by matches and colors other than white
are available on request.)
Page 1 of 4 JULY, 2004 TFP181