Correspondence October 17, 2007
Jim Standring
Cedar Mill Townhomes II, LLC
12670 SW 68t Ave. Suite 400
Tigard, OR 97223
RE: NEW SINGLE FAMILY RESIDENCE
Building Permit: MST2007 -00175 Construction Type: VB
Address: 15645 SW 81st Ave. Occupancy Type: R -3
Area: 2376 sq. ft. Stories: 2
The plan review was performed under the 2005 Oregon Residential Specialty Code. The review
of the submitted plans will be completed when the following information is provided.
1. Provide (2) copies of the manufactured floor framing layouts and calculations. R106.1.1
Note: Any change in orientation of floor joists due to plan review items above
must be shown on manufacture's floor joist layout. Show doubled joists under the
edges of the braced panel at the right front of the bonus room.
2. Show the HD8A missing from the braced panel on the left side of the rear wall on (2)
copies of the plan page.
3. Show the HD8A missing from the braced panel at the back of the left wall on (2) copies
of the plan page.
4. Show the MST48 strap a minimum distance of four feet from the other strap at the
upper left braced panel on (2) copies of the plan page.
5. Revise the one story portal frame detail to reflect the two story portal frame situation
actually being built.
6. SHOW smoke detectors on the plan where required.
7. SHOW bathroom fans on the plan where required.
8. When responding, provide an itemized letter stating in what way each issue has been
addressed in the revision.
When submitting revised drawings or additional information, please attach a copy of the
enclosed City of Tigard, Letter of Transmittal. The letter of transmittal assists the City of
Tigard in tracking and processing the documents.
Respectfully,
Loraine Sellers
Plans Examiner
loraine @tigard - or.gov
Phone: 503.718.2708
Fax: 503.624.3681
PROJECT ADRESS: REA,/ ,N
15645 SW 81 Ave.
Lot 11 Gage Forest, 2001
PERMIT #: MST2007 -00175 g A M
PLANS REVISED BY: at
JEFF GERBERG - 503 - 218 -5121 t DIVISION
PLAN CHECK RESPONSE:
Item #1:
Revised manufacturer's floor framing layout to be provided by builder.
Item #2:
Added missing hold downs on the floor plans & foundation page.
Item #3:
Added missing hold downs on the floor plans & foundation page.
Item #4:
Added missing strap as needed on upper floor plan.
Item #5:
Revised portal frame detail sheet as requested.
Item #6:
Added smoke detectors where needed
Item #7:
Added exhaust fans where needed.