Specifications GALIFCO OREGON Fax:541 -485 -6927 Mar 21' '02 1100 P.05
1"OR011gos - pppnmwn LMIWU P
PORTA-KING PRENSEMMIED 11111101110 $1111
• AM OM WO WI to TIONI SAL \ COMM s*u
I
DURASTEEL SMOKING SHELTER SPECIFICATIONS
Download Dura;teeI Smoking Shelter Specifiiationa (32KB)
PART 1 - GENERAL
1.1 Provide all labor, equipment and materials to fumish and install prefabricated portable steel building(s)
where shown on the drawings.
1.2 Related work SpecUled Elsewhere.
1.2.1 Electrical service supply and connection.
1.2.2 Site/Foundation work.
1.2.3 Unloading, placement, installation and anchoring.
1.2.4 Plumbing and piping (when required).
1.3 Quality Assurance
1.3.1 Structures shall be the product of a manufacturer with a minimum of 10 years-documented
experience in the design and fabrication ofportable steel buildings.
13.2 The approved manufacturer is Porta -King Building Systems, 4133 Shoreline Drive, Earth City,
63045, Ph. 1-800-284-5346, and Fax 1 -314- 291 -2857.
1.3.3 Prefabricated buildings by manufacturers other than the one approved shall submit sufficient d,
enable approval to be given. As a minimum: Design drawings and /or calculations, applicable
certifications, catalog information, and color samples showing equal range of variety.
1.3.4 Electrical devices dory installed within the prefabricated building shall be UL listed. Factory
installed wiring system shall bear UL Classification insignia certifying compliance with the National
Electrical Code, 1990 & 1993 editions.
00 1.3.5 Adherence to applicable portions of state and local building codes is the responsibility of the o
in Building manufacturer shall not be responsible for permits, special engineering calculations, or
architectural type drawings unless otherwise notified in writing 3 -weeks prior to release of bid docut
1.3.6 Design Loads: 50 PSF live load, 30 PSF wind load.
00
1.4 References
1.4.1 Upon request, the prefabricated building manufacturer shall provide the locations and owners t
three (3) similar buildings that have been in service more than three (3) years. This will allow the
architect/owner to inspect on site and obtain a statement from the owners on the quality of workman:
(fit and finish).
1.5 Submittals
1.5.1 Upon award of order, manufacturer shall prepare and submit copies of shop drawings as requin
1 of3 3/19/02 1205 PM