Permit (29) CITY OF TIGARD REROOF PERMIT
s COMMUNITY DEVELOPMENT Permit#: RER2023-00022
T f G A R.D 13125 SW Hall Blvd.,Tigard OR 97223 503.718.2439 Date Issued: 7/25/2023
Parcel: 1S136AD06507
Jurisdiction: Tigard
Site address: 11460 SW PACIFIC HWY
Project: Quality Inn Subdivision: WAY LEE
Lot: 3
Project Description: Remove and replace roofing, metal coping caps,wall skirt,and counter fleshings.
Contractor: COLUMBIA ROOFING& SHEET METAL Owner: J&J HOSPITALITY GROUP LLC
18525 SW 126TH PL JAIDEN INVESTMENTS LLC
TUALATIN, OR 97062 S&S REAL ESTATE DEVELOPMENT LLC ET
AL
PO BOX 1120
PORTLAND, OR 97075
PHONE: 503-684-9123 PHONE:
FAX: 503-684-1458
FEES
Description Date Amount
Permit Fee 05/30/2023 $1,734.11
Specifics: 12%State Surcharge-Building 05/30/2023 $208.09
Type of Use: COM
Class of Work: ALT Type of Const:
Occupancy Load:
Stories: Height: 0 ft
Project Valuation: $203,362.33
General Information
Building Area: 0
Re-Roof Area: 0
Roof Class:
Tear Off:
Overlay:
Existing Roof Layers:
Parapets:
Total $1,942.20
Required Items and Reports(Conditions)
This permit is issued subject to the regulations contained in the Tigard Municipal Code, State of OR. Specialty Codes and all other applicable law. All work
will be done in accordance with approved plans. This permit wit expire if work is not started within 180 days of issuance, or if work is suspended for more
the 180 days. ATTENTION: Oregon law requires you to follow the rules adopted by the Oregon Utility Notification Center. Those rules are set forth in OAR
952-001-0010 throug 952-001-0090. You may in a copy of the rules or direct questions to OUNC by calling 503.232.1987 or 1.800.332.2344.
�Issued By: ! ✓ 9 1 Permittee Signature: 4
Call 503.63tp. 75 by 7:00 a.m.for the next available inspection date.
This permit card shall be kept in a conspicuous place on the job site until completion of the project.
Approved plans are required on the job site at the time of each inspection.
Building Permit Application
Re-Roof RECEIVED Pt)I{OI H( L ( i: OsiI.A
City of Tigard Dale Rece/Bived: Ii!
rj /1raw f Pe '' .)-0a? _$9Q0.?
11 MAY 1 1 2023 13125 SW Hall Blvd.,Tigard,OR 97223 I' h Pion Review
Phone: 503.718.2439 Fax: 503.598.1960 Date/B : Other Permit:
T I ci n R D Inspection Line: 503.639.4175 CITY OF TIGARD Date ReadyBy: Jura. ® See Page 2 for
igna
Internet-. www.tigard-or.gov n NotifiedRvledlod: Supplemental Information
BUILDING C' E`vfai(,rd el/
TYPE OF WORK REQUIRED DATA:1-AND 2-FAMILY DWELLING
❑New construction ❑Demolition Permit fees*are based on the value of the work performed.
Indicate the value(rounded to the nearest dollar)of all
®Addition/alteration/replacement ❑Other: equipment,materials,labor,overhead,and the profit for the
CATEGORY OF CONSTRUCTION work indicated on this application.
El1-and 2-family dwelling ElCommercial/industrial Valuation: $
ElAccessory building IN Multi-family Number of bedrooms:
❑ El Number of bathrooms:
Master builder
JOB SITE INFORMATION AND LOCATION Total number of floors:
Job site address:11460 SW Pacific hwy, Tigard, OR 97223 New dwelling area: square feet
City/State/ZIP:Tigard, OR 97223 Garage/carport area: square feet
Suite/bldg./apt no.: Project name:Quality Inn Tigard Tear Off 2023 Covered porch area: square feet
Cross street/directions to job site: Deck area: square feet
Pacific Hwy W&SW 68th PkWy Other structure area: square feet
REQUIRED DATA:COMMERCIAL-USE CHECKLIST
Subdivision: Lot no.: Permit fees*are based on the value of the work performed.
Tax map/parcel no.: Indicate the value(rounded to the nearest dollar)of all
equipment,materials,labor,overhead,and the profit for the
DESCRIPTION OF WORK work indicated on this application.
See Scope of Work valuation: $203,362.33
Existing building area: 13,628 square feet
New building area: 13,628 square feet
PROPERTY OWNER ❑ TENANT Number of stories:4
Name:Aisling Creation, LLC Type of construction:Re-roof
Address:11460 SW Pacific hwy,Tigard, OR 97223 Occupancy groups:Group R
City/State/ZIP:Tigard, OR 97223 Existing:Group R
Phone:( ) Fax:( ) New:Group R
® APPLICANT ® CONTACT PERSON NOTICE
Business name:Columbia Construction Services All contractors and subcontractors are required to be
Contact name:Jacob Epling licensed with the Oregon Construction Contractors Board
under ORS 701 and may be required to be licensed in the
Address:18525 SW 126th Place jurisdiction in which work is being performed.If the
ciry/state ZIP:Tualatin, OR 97062 applicant is exempt from licensing,the following reasons
apply:
Phone:( 503)866-8195 Fax::( )
E-mail:jacob@reroofnow.com
CONTRACTOR
Business name:Columbia Construction Services BUILDING PERMIT FEES*
Address:18525 SW 126th Place (Plcasereferto fee schedule)
Structural plan review fee(or deposit):
City/State/ZIP:Tualatin, OR 97062
FLS plan review fee(if applicable):
Phone:(503)648-9123 Fax:( )
CCB lie.: Total fees due upon application:
116607
6 (�q Amount received:
Authorized signature: This permit application expires if a permit is not obtained
Print name:Jacob plingDate:5/9/2023 * within 180 days after it has been accepted as complete.
Fee methodology set by Tri-County Building Industry
Service Board.
1:11Buildir \Permits\ROOF-PermitApp.doc 10/01/09 440-4613T(11/02ICOMJWEB)
City of Tigard: Re-Roofing Permit Checklist
Page 2-Supplemental Information
RESIDENTIAL (One-&Two-Family Dwelling)
❑ REPAIR (major) plan review required by plans examiner:
building permit is required when structural changes are made or the space sheathing is
removed or replaced.
SUBMIT TWO(2) SETS OF PLANS SPECIFYING:
A. Roof area and nearest street.
B. Attic vents: Provide 1 sq. ft. for each 150 sq. ft. of attic space. Vents shall be
located in the upper 1/3 of the roof. Provide 1 sq. ft. for each 300 sq. ft. when
eave and attic venting is provided.
Note: No permit is required for residential re-roof if not more than two (2) layers of
roofing will exist upon completion of the re-roofing.
COMMERCIAL(includes multi-family and condominiums)
El RE-ROOF: Pre-inspection is required for all roofs sloped 2:12 and less. Call
503.639.4175, for code 295 Miscellaneous inspection after permit is issued.
❑ PLAN REVIEW:
Note: Depending on the conditions noted at the pre-inspection,plans may be required
to address any non-conforming items.
VALUATION OF PROJECT: $
sq.ft. of roof area
Permit Fee based on valuation: $
(see Building Permit Fees chart)
12% State Surcharge: $
65% Plan Review Fee: $
(Required for major repairs of residential and
special purpose roofing of commercial projects.)
TOTAL: $
I:\Building\Permits\ROOF_PermitApp.doc 2
RECEIVED
Scope of Work MAY 1 1 2023
TPO Adhered Systems CITY OF TIGARD
BUILDING DIVISION
1. Tear off the existing roofing down to the last layer of roofing and overlay.Tear off any roof-
related metal coping caps, wall skirt and counter flashings and dispose of offsite in a legal manner.
2. Furnish and install 1 layer of 3.0"Secursheild poly iso over the last layer of roofing by adhering
with low rise foam adhesive.
3. Over the Securshield iso, furnish and install a new 60 mil reinforced TPO roof membrane and
adhere.
4. All field and base flashing seams will be cleaned before being hot air welded.
5. Furnish and install new TPO base flashings around all curb penetrations.
6. Furnish and install new TPO base flashings around the roof hatch.
7. Fabricate and install a new standard color 24-gauge metal hatch flashing under the metal
flashing flange of the roof hatch to hold the TPO membrane in place.
8. Furnish and install pre-manufactured inside/outside TPO corner flashings at curb penetrations,
thru wall scupper drains, pitch pans and wall flashings.
9. Furnish and install new pre-manufactured pipe boots on all pipes up to 6" in diameter complete
with a new stainless steel clamps and sealant.
10. All pipes larger than 6" in diameter will be field wrapped with unreinforced TPO membrane
complete with a new stainless steel pipe clamp and sealant.
11. All pipes where a pre-manufactured pipe boot is not feasible will be field wrapped with
unreinforced TPO membrane complete with a new stainless steel pipe clamp and sealant.
12. Furnish and install TPO patches at all T-Joints in the field membrane.
13. At all gas and electrical lines,furnish and install pre-manufactured TPO pitch pans.
14. Furnish and install pre-manufactured TPO pitch pans around the line sets off the condensing
units.
15. Furnish and install a one part poly-urethane rubberized pitch pan sealant in each pitch pan.
16. Tear off old wood on walls and furnish and install new TPO base flashings at all parapet walls
that will extend up and across the top of all walls.
17. Furnish and install a metal anchor bar to the top of the flashing and mechanically attach every
12"on center.
18. Fabricate and install new TPO clad thru wall drain flashings and adhere. Furnish and install new
TPO flashings to the drain.
19. Furnish and install new TPO membrane in the roof drain assemblies and set in water cut off
mastic. Install the clamping ring to the drain body compressing the TPO membrane into the water cut off
mastic to insure a watertight seal. Reinstall drain bolts complete with washers, replacing as needed on a
time and materials basis.
20. Reinstall the drain screens back in place once the drain rings are installed.
21. Fabricate and install new 24 gauge galvanized clip metal to be installed along the outside of all
parapet walls. Mechanically attach the clip to the wall.
22. Fabricate and install new pre-painted standard color 26 gauge surface mounted metal counter
flashings along the inside walls.These flashings will counter over the new TPO membrane flashings and
be mechanically attached 12"on center. Install a polyether caulking to the top of the flashing to ensure a
watertight seal.
23. Fabricate and install new pre-painted standard color 24 gauge metal counter flashings around
each HVAC unit and mechanically attach to the curb with new neoprene gasketed fasteners.
24. Upon completion of all the work we will have the manufacturer's representative inspect the roof
for completeness and for the issuance of the factory warranty.
25. Upon completion of the above work, remove all tools and debris and leave the site in a clean
and orderly condition.